How to use

How do I apply the lashes?

1. Size the lashes. 

Before gluing the lashes on, you will need to make sure they are not too wide for your eye. Hold the lash strips up against your eyelid, and trim them down on the sides if necessary. Trim any excess from the outer (longer) corner as lashes should always be longer toward the outer side.

2. Apply the lash glue to the outer seam of the eyelash strip with an applicator or small brush. Allow the glue to dry and get tacky for 15-20 seconds before applying it to your lashes.

3. Place the strip on your eyelid, positioning it as close as possible to your natural lashes. Bring the strip down from above, not from the front. This is to ensure that you get as close as possible to your lashline. Hold the lashes with tweezers or your finger in the centre, secure in the middle of your lash line and then press the outer corners into place.

4. Allow the glue to dry naturally. Once the strip is in place, you do not need to press or hold it. 

How do I care for/clean the lashes?

Be gentle with your lashes. remove from eye with fingers. pull gently from outside corner inwards and once removed, store in packing provided to keep safe and clean.

Remove glue - use a pointed tweezer to very gently remove any excess glue from the lashes after every wear.

Avoid mascara - Mascara, especially waterproof mascara, can damage mink so use on your natural lashes before applying Brody Beauty lashes. Do not attempt to curl your Brody Beauty lashes. 

Using a cotton tip, wipe some oil free makeup remover across the band of the lashes to clean off any excess makeup or dirt.